If you're inserting horizontal dividers, measure the height of your cube. For vertical dividers like mine, measure the width of your cube.Simply take my formula and apply it as needed! Keep in mind these numbers will vary based on the size of your cube, the width of your divider wood, and how many dividers you're planning to insert. How to Make the Slot System for Your Dividers But passion breeds excellence as they say, so I'm getting pretty good at fractions these days. While they're drying, grab a pen and paper for some math fun.Īnd by fun I mean torture, 'cause I hate math. Give your dividers a coat of paint if you like. You can always sand the edges a bit if they don't slide in perfectly. Now see if your squares slide into your cube. They were actually trimmed closer to 13-1/8" once all was said and done. I found it helpful to have a miter saw because I needed to trim the edges a bit to get them to slide in juuuuust right. If you don't own a table saw, ask the guys at Lowe's to cut your pieces for you. Using a table saw, cut your plywood into 15" x 13 1/4" squares. scrap wood for your slots: mine are 1/4" plywood ripped to 1 inches wide, but lattice or quarter round would also work.paint (optional) I used Ultra White Behr Semi-Gloss.one 4ft x 8 ft sheet of 1/4" plywood (this is enough to make 21 dividers).one Ikea KALLAX unit (mine is actually a 4-unit Kallax stacked on top of an 8-unit Kallax).Here's how I made these sweet little dividers.ĭisclaimer: this post includes affiliate links, which means I may earn a small commission should you decide to purchase any of these supplies.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |